TheQGentleman
Mar 31, 2019
We all know that feeling when you’re halfway through trying to fix the pipes and realize you’ll need to call the Plumber. It’s an embarrassing moment. Saying this though, needing the services for sewer line repair by Zurn Plumbing (or one closer to your area) could actually save you some time and know that the job was left to the professionals. As much as you like to say you can do it all, getting some help isn’t always a bad thing. You may be pretty handy and love to fix stuff around the house, but what happens when your wife calls about a broken sink and you don’t know the first thing about plumbing? Although we take it for granted, plumbing powers a lot in our homes from sinks and showers to hot water and ice. Studying up on basic plumbing knowledge can help you avoid calling the plumber and help you from fumbling around your house. However, there is no shame in having to make use of an Anytime Plumbing emergency 24 hour service when your plumbing situation becomes absolutely dire.
The
first step to most plumbing problems is locating and cutting off your water
supply. Know where your main valve is and how to turn it off so you can avoid
excess water leaks. Most valves are located near the street and or around the
house, frequently the basement, and resemble a wheel or lever. Cutting off the
water is as simple as turning the wheel clockwise slowly until it stops, or
pushing down the lever. If your unsure if the water has been fully stopped just
test it at a sink.
In
addition to the main valve many appliances have smaller valves attached to stop
the water for a particular place. These can be found on toilets, sinks, and
washing machines usually behind the appliance and low to the floor. The valves
for bathtubs and showers can be trickier to find and these appliances may have
cut off valves in an adjacent closet or basement. If you know ahead of time
where these valves are you can avoid water filling your home and causing damage
by quickly stopping it before it becomes a problem. However, if none of this tends
to make much sense to you, you may be better off calling a commercial or residential plumber in Croydon to solve your issue.
Your
water bill spiking up can also be a cause for concern, not only for your
wallet. Knowing where your water meter is, if you have city water, or buying a
meter and knowing how to read it can help you monitor your water usage and
alert you to any problems in your plumbing. Water meters can usually be found
around your home or under a street cover. You can also contact your water
company to ask questions and help locate a meter.
Test your water pressure regularly, either by asking your water company or buying a tester for about 10 dollars. These gauges attach to your outside faucet and gives you a reading of the current pressure when turning on the spigot. The household standard is 80 pounds per square inch of pressure.
To
adjust the water pressure you will need to find your homes pressure regulator,
often found around the house, near the main water cut off valve, or near the
street with the water main. Most are covered but inside you will find a wing
nut or bolt to adjust pressure. Have someone watch the pressure while you
slowly turn the bolt clockwise to increase pressure and counterclockwise to
decrease pressure.
You
can check your pressure for hidden leaks regularly by turning off your water
supply and waiting about 15 minutes. If the numbers on your water meter are the
same when you return then there are no problems, a higher number however means
problems. Unknown or hidden leaks can be a small burst in your buried pipes,
but make sure it’s not a toilet running or a sprinkler system as these can also
be the cause of the higher numbers.
While
water heaters typically last 10 to 12 years, they almost always start to leak
before that time is up. Make sure you know where the shut off valves on the
water heater for electric or gas, and water are. If your heater is gas powered
you can turn it off by turning the knob clockwise. If your heater is electric
you should find the breaker or fuse to turn it off. The water supply is usually
located near where the heater connects to the main water line, and is a handle
or lever. To turn it off you’ll need to stop the cold oncoming water as opposed
to the line that carries hot water out. Check all these pipes and accessories
regularly for leaks.
These are just a few tips to help you fix a problem before it gets out of hand. Knowing the location of valves and how to use them, as well as knowing how to read and test pressure can prevent serious damage to your home. There’s no need to call a plumber if you catch the problem before it arises, and if you read up on knowledge beforehand, you’ll be ready for any emergency. If a professional opinion is required however, do not be afraid to call for help! Any local Atlanta plumber will be able to give you the help and instruction you need to fix any issue you might have.